中文
The following information is sourced from the laboratory of Jiangsu Taihua Plastic Factory of Taihua Group
Melt flow index, according to the ASTMD1238 testing standard, measures the numerical value of the flowability of plastic materials during processing.
Measure the impact mass and energy of a 50% plastic film or thin sheet sample when it is damaged under a free dart impact at a given height.
Simulate the harm caused by sunlight, rainwater, and dew to ton bags using ultraviolet (UV) lamps, and test the aging resistance value.
Monofilament and fabric are tested and inspected for timing, speed, load, elongation, burst, and elastic recovery rate.
Metal detection, including both iron and non-ferrous metals, has high detection sensitivity and is a basic test for every ton bag before leaving the factory.
Microcomputer controlled ton bag safety load test, conducting comprehensive load testing on the bag body and sling of the ton bag.
Surface resistance detection of conductive ton bags.
Clean the blower to blow air into the inner lining of the ton bag, and use incandescent lighting to check the cleanliness.
